HOME  PROPERTIES  INFORMATION  STATEMENTS

 

Information
Please Read Before Using

 

HTS-735^II  Fluxless Brazing Rod was developed for Aluminum, Magnesium, cast aluminum and cast Magnesium including most of their alloys.  It has it's most strength and is most easily used on these metals.  HTS-735^II Fluxless Brazing Rod also works well on most of the other Non Ferrous metals EXCEPT Stainless Steel.

 

GENERAL INFORMATION

Follow these 3 simple steps and you will have a strong perfect weld every time.

• Step # 1:  Clean the area to be worked with a file, grinder or wire brush.  This "2nd Generation" welding rod does not require a special brush in order to make it work!

• Step # 2:  Heat the work surface (not the brazing rod) until the work surface is hot enough to melt the rod.  Do this just as you would if using a solder.  DO NOT PUT THE ROD IN THE FLAME.  You must bring the temperature of the base metal up to the melting point of the HTS-735^II Fluxless Brazing Rod.  You must open the pores of the work surface with heat in order for the rod to penetrate the surface.

• Step # 3:  When the weld is completed, always allow to cool naturally.  Propane works well on most weights up to 1/4 inch.  Note:  Remember the thicker the material to be welded, the longer it takes to reach the proper temperature.  On heavier work or to save time, you can use oxygen acetylene.  Always use a Rosebud tip or a neutral flame with oxygen acetylene.  Never put the rod in the direct flame while brazing with HTS-735^II Fluxless Brazing Rods.

INSTRUCTIONS